Avital Tornado 2 Manual de Instalação descarregar pdf (Página 6)

Installation Procedures

Con trol Unit

1. Select a location under the dash that will allow you to use tie wraps to

securely fasten the control unit.

2. Mount the control unit as high as possible to ensure maximum range.

3. Do not mount the control unit near moving parts.

4. Avoid areas that are in the direct path of air blowing from the vents.

5. Route wires from this point, leaving slack for ease of service.

An tenna

1. Do not shorten or lengthen the antenna.

2. Route the antenna away from the control unit.

3. Keep the antenna as far away from metal and wire harnesses as possible

to optimize range.

Wir eloom

1. Plug the wireloom securely into the control unit.

2. Route wires from the control unit directly to each connection point.

3. Separate the RED, BLACK, RED/WHITE, VIOLET and TAN wires.

4. Sleeve the wires with vinyl tubing or electrical tape and route them

through an existing rubber grommet into the engine compartment.

5. If an existing grommet is not available, drill a hole and install a snap

grommet.

Valet Switch

1. Discuss placement with the owner.

2. Choose a location for the valet switch that is hidden, but convenient for

the owner to access.

3. Drill a ¼" hole and mount the switch.

4. Route the valet switch wires to the control unit.

5. Plug the valet switch BLUE connector into the control unit BLUE plug.

Tornado

Installation Manual 1/5/98

1 2 3 4 5 6 7 8 9 10 11 ... 14 15

Sem comentários

Avital Tornado 2 Manual de Instalação Página 6